Mantis 7566 Manuel de l'opérateur télécharger pdf (Page 13)

Dealer

If you suspect the engine is

overlled the following procedure

should remove the excess oil from

the crankcase and valve cover.

If the engine is overlled, oil will

enter the crankcase and it does

not simply pour out of the oil ll

opening. The excessive oil has

to be pumped out as the engine

runs. Checking the oil level and

draining any excess between

multiple 30 second running

intervals will bring the oil back to

the proper level.

1. Place the engine on a level

surface resting at on the front

loop handle and remove the

oil ll cap/dipstick. Use a catch

basin for any oil that overows

from the oil ll opening.

2. Replace the oil ll cap/

dipstick and run the engine

for approximately 30 seconds

then repeat step one. Continue

steps 1 & 2 until oil no longer

overows when the oil ll cap/

dipstick is removed.

3. Once the oil level is corrected

the engine may continue

to smoke while running for

several minutes while the

residual oil burns off.

MANTIS

DELUXE XP TILLER PROPER

OIL FILL/LEVEL CHECK POSITION

Engine must be resting on a at surface on

the fuel tank

This position does

not allow for a

proper oil level

reading and may

cause overlling.

CORRECTIVE ACTION

Mantis

Deluxe XP Tiller Fueling & Starting

Mantis

Deluxe XP Tiller Operation

If engine does not stop when switch is put in the stop position, release the throttle, allow engine to idle.

Put the tiller down, and slide the choke lever to the cold start (closed) position. Have product serviced.

A SPECIAL FEATURE

(With the idle set properly and the

engine running)

Even when the engine is running, the

tines won’t turn unless you squeeze

the throttle trigger on the handlebars.

And, when you release the throttle

trigger, the tines will stop

A TIP FOR EXTENDING

YOUR ENGINE’S LIFE

After you start the engine, let your

tiller warm up for two to three

minutes before you use it. Then,

before you put your tiller away, let it

idle for a minute to give the engine a

chance to cool down.

OPERATION

With engine running, and both hands

on the handles, hold down the

throttle lock out lever (Figure 1),

then squeeze the throttle trigger

gradually to increase the engine

speed and engage the tines.

NOTE: This step must be repeated

each time your tiller trigger is

released.

Figure 1

401780 Mantis XP Deluxe tiller manual.indd 13 1/24/13 4:07 PM

1 2 ... 8 9 10 11 12 13 14 15 16 17 18 ... 25 26

Commentaires sur ces manuels

Pas de commentaire

Mantis 7566 Manuel de l'opérateur Page 13

Commentaires sur ces manuels

Produits connexes et manuels pour Mini-faucheuses Mantis 7566