When servicing the snow shovel, use only the
manufacturer's original replacement parts. Inspect the
drive belt for wear once per year or every 50 hours of
operation, whichever comes rst. If the drive belt needs to
be replaced, follow these steps.
In order to avoid serious personal injury, turn off the snow
shovel and allow it to cool down. Unplug the snow shovel
before performing any maintenance.
• Using a 17-mm wrench or socket, remove the nut from the
left hand side of the impellor shaft (Fig. 6).
• Remove the ten (10) screws from the belt cover using a
phillips screwdriver. Remove the belt cover (Fig. 7).
• Remove the ange lock nut and the washer from the
impeller pulley shaft (Fig. 7).
• Remove 3 screws from the impeller pulley bracket shown
in (Fig. 7).
• Remove the impeller pulley bracket (Fig. 7).
• Pull the belt tensioner (idler arm) away from the drive
pulley. Remove the damaged or broken belt from the
impeller pulley and the drive pulley inside the housing.
Discard the belt in the proper manner (Fig. 8).
• Loop the new belt around the drive pulley and the impeller
pulley (Fig. 8). Pull the belt tensioner (idler arm) away from
the drive pulley in order to install the belt around the drive
pulley.
• Reinstall the impeller pulley bracket with the three (3)
screws.
• Reinstall the washer and the ange lock nut. Tighten the
nut.
• Reinstall the belt cover with the ten (10) screws. In order
to facilitate the installation, position the narrow part of
the cover into the recess of the housing and install the
two top screws and then push the rest of the cover down
into recess and over the rotor shaft. Tighten all ten (10)
screws.
Use only the manufacturer's original replacement parts.
• Place the snow shovel on the ground or on a work bench.
Position the snow shovel so that the impeller is facing up.
• Remove the three (3) screws that are located beneath the
impeller that secure the scraper to the housing using a
phillips screwdriver (Fig. 9).
• Remove the scraper, and discard it in the proper manner.
• Snap the new scraper into position, and attach it to the
snow shovel by reinstalling the three (3) screws.
Maintenance
Maintenance
12 8 Amp 12” Electric Snow Shovel Operator’s Manual
shovel to a power source.
any maintenance.
WARNING
WARNING
Nut
Cover
Impeller Pulley
Belt Tensioner
Impeller
Pulley
Belt
(10 pages)
(10 pages)
Manymanuals.com
Manymanuals.de
Manymanuals.fr
Manymanuals.it
Manymanuals.pl
Manymanuals.cz
Manymanuals.es
Manymanuals-pt.com
Commentaires sur ces manuels