Mantis 8112 Manuel de l'opérateur télécharger pdf (Page 8)

IMPELLOR REPLACEMENT

Maintenance

Maintenance

 

• Remove the nut from the left

hand side of the impellor shaft.

• Remove the nut from the

impellor shaft.

• Remove the pulley and belt.

• Withdraw the old/damaged

impellor. Be sure to keep the 2

spacer washers from the right

hand side of the impellor.

• Remove the 10 screws from

the side cover.

• Remove the 3 screws holding

the pulley support plate.

• Remove the 2 screws and 2

washers.

• Remove the impellor shaft nut

from the right hand side.

• Insert the impellor shaft in the

new impellor and place the

2 washers on the right hand

side.

• Be sure not to lose the 2

springs.

• Remove the plate and the two

spacer washers.

• Withdraw the impellor shaft

from the left hand side.

spring

spacer washer

spacer washer

screw and washer

1

4

7

10

2

5

8

11

3

6

9

12

• Replace the pulley support

plate and the 3 retaining

screws.

• Place the lower spring into

position and slide the side

cover up using slight pressure

to hold the spring in place.

• Be sure to route the belt

correctly, as shown.

• Replace and tighten the

impellor shaft washer and

nut.

• Replace and tighten the

remaining screws and the nut

and washer.

• Replace the 2 spacer washers

on the impellor shaft.

• Place the upper spring into

position and then finger

tighten the cover plate into

place as shown.

• Re-install the impellor shaft

nut and washer on the right

hand side, and tighten.

• Place the impellor and shaft

back into the front scoop.

• Place the pulley back onto the

impellor shaft.

• Replace the 2 screws and 2

washers onto the impellor.

screw and washer

15

14

spring

spring

impellor shaft washer and nut

13

18

21

16

19

22

17

20

23

 

1 2 3 4 5 6 7 8 9 10

Commentaires sur ces manuels

Pas de commentaire